Victron Quattros, MultiPlus-II Inverters & So Much More
READY RIGHT OUT THE BOX!
Family Owned. Real Support. No Commission Sales.
The hardware is the easy part. The setup is where we earn our keep.
Anyone can sell you the hardware. We set it up before it ships. A Victron inverter runs on its configuration as much as its components. Left on factory settings, it is a weekend of troubleshooting waiting to happen. We program and bench-test yours first, so it comes to life the moment you connect it.
Free Inverter Programming
We load your inverter with the right charge profile, voltages, DVCC and AC limits before it ships. Programming a Victron inverter requires the MK3-USB interface, a tool that costs real money, just to run initial setup. We already have it, so you can skip this step.
Zero Dead On Arrival
Every inverter runs on the bench and gets verified before it goes in a box. The result: we have shipped exactly zero dead-on-arrival inverters. You wire it in knowing it already powered up correct here first.
Cables Thoughtfully Matched
Victron is strict about equal cable length when you parallel inverters, or current sharing falls apart. We cut and crimp matched sets so paralleled units stay balanced. We also stock pre-made 6/3 and 6/4 SOOW cord with the correct ferrules, exactly what many of the 3kVA inverters call for.
Support All The Way
With zero commissions we are with you before the sale while you spec it, through the build, and on the first night something acts strange. You reach specialists who build these systems, not a script reading off a manual. Same team, start to finish.
MPPTs or solar chargers are easily set up from your phone in a few minutes so we don't normally break open the packages for that. But if you run a Cerbo GX, we can push inverter setting changes remotely through VRM, so you never have to buy the MK3-USB at all.
Featured Inverters
Looking for chargers, MPPTs, GX devices, or Lynx distribution? Shop all Victron Energy products.
MEET YOUR TECHS
Real names. Real Victron knowledge. Real people who pick up.
When you call Current Connected, you reach the people who actually know the gear. No script, no handoff to someone reading a manual for the first time.
AJ
Victron Specialist
Knows these systems end to end, from sizing to the inverter config to commissioning. Whatever you call about, AJ can run it down rather than pass it off.
Malik
Victron Specialist
Has built and configured more of these than most installers see in a career. No question gets handed to someone else to figure out later.
Fern
Victron Specialist
Stays with you from the first quote through the night you are commissioning. You are never bounced between people who do not have the context.
And the rest of the team behind them. No matter who answers, you get taken care of. That is the whole point of buying here.
HOW TO CONFIGURE YOUR SYSTEM
Let us guide you through it!
Tell us what you need
Your battery chemistry, bank voltage and what you need the system to do. Not sure? If you are not there yet, we will help you spec it from scratch.
We program the inverters
Charge profile, DVCC, current limits and AC settings written to your exact parameters with the MK3-USB.
We bench test the units
Verified on the bench before it ever goes back in the box, so you do not discover a problem after it is already mounted.
It ships ready to go
It shows up configured and confirmed. Mount it, wire it, power it up. And the configuration costs you nothing extra.
ABOUT PRICING
Cheapest box on a shelf is not the cheapest system.
We keep our Victron pricing honest, but honest is not always the lowest number you will find online. That lower number tends to skip the programming, the matched cabling, and the person who answers when a setting looks wrong. You pay for it one way or another.
+ Programmed to your system requirements and bench tested, not handed to you on factory defaults.
+ Equal-length cabling for parallel banks, cut and crimped to match.
+ A specialist who answers before, during and after the build.
+ One team accountable for the whole order, not a marketplace listing.
From the water to the work site
Marine, mobile, off-grid home, industrial. The Victron lineup covers all of it, and we configure each unit for the job it is actually walking into.
Home Backup and Off-Grid
MultiPlus-II and Quattro systems for whole home backup and off-grid homes, with generator support and 120/240V split phase options.
RVs, Vans, and Overland Rigs
MultiPlus-II inverters and Orion DC-DC chargers that keep your rig powered from shore power, solar, and the alternator.
Boats and Marine
Inverter chargers, SmartShunt battery monitors, and galvanic isolators set up for shore power and your house bank.
Work Trucks and Fleets
Quiet AC power on the job site from your vehicle’s battery bank, without idling the engine all day.
WHAT OUR CUSTOMERS SAY
The service is what we're known for.
"It's just great when you call a business, and someone actually answers the phone."
This buyer ordered two MultiPlus-II inverters. When a freight carrier banged one up in transit, something Current Connected had no hand in, we walked him through his Route protection claim and made sure he was covered. A fully paid replacement shipped out quickly, and he got to keep the lightly marked unit on top of it. He said he will be buying from us again.
Verified buyer, solar power forum. Read the original thread here
★★★★★
“Shout out to Malik Duff for fantastic technical support... Above and beyond support!!!”
Harold Z., Google review. Read it on Google
★★★★★
“...AJ Furcron from the tech sales team handled it flawlessly.”
Kelly A., Google review. Read it on Google
Zero
Inverters shipped dead on arrival. Every one is tested first.
Since 2020
Family owned, building real power systems.
In-House Fab
Tens of thousands of cables crimped on our own equipment.
Victron FAQ
Yes. Current Connected is an authorized Victron Energy distributor. We ship from Hayden, Idaho, and you can also arrange will call pickup.
Yes, at no extra cost. Tell us your battery chemistry, bank voltage, and how you will use the system, and we load the charge profile, DVCC, current limits, and AC settings with our MK3-USB before the inverter goes in the box.
Not if we program it for you. If your system has a Cerbo GX, we can also push setting changes remotely through VRM later, so you may never need to buy one.
The Quattro has two AC inputs, so it can manage grid and generator power on its own, and it comes in larger sizes. The MultiPlus-II has one AC input and fits most systems with a single AC source.
Most of the lineup comes in 48V versions, including the MultiPlus-II 48V 3kVA and 5kVA and the Quattro 48V 10kVA. A 48V system draws less current than 12V or 24V for the same power, so it is the usual pick for homes and larger off-grid builds. Contact our support team and we’ll help you match one to your bank.
Yes. Two 120V units can be paired for 120/240V split phase, and the 2x120V MultiPlus-II models can pass both legs of 50A shore or grid power straight through. Contact our support team and we’ll help you pick the right setup.
Victron calls for matching DC cable lengths and sizes on paralleled units so current shares evenly between them. We cut and crimp matched sets so your paralleled inverters stay balanced.
Buy your Victron from people who answer.
Order it configured, tested and backed by a real team. Or call first and let us help you get the system right.