SOK Battery | 206Ah “H” 12v | Heated & Bluetooth | LiFePO4 Battery

  • 7-Year Manufacturer Warranty + Current Connected 3 Year Extended Warranty* (10 Years Total)!
  • 12V LiFePO4 Deep Cycle Lithium Iron Phosphate Battery, 206ah Capacity
  • Built-in Smart Battery Management System (BMS)
  • Built-in Heating System for increased cold-weather charging range
  • Bluetooth Connectivity for monitoring
  • 4000~8000 cycle life & Maintenance-free
  • Over charge & over discharge protection
  • Over current & short circuit protection.
  • Detachable cover, user serviceable BMS and cells.
  • High & low temperature disconnects
  • Sizes Also available: 12 Volt 206Ah
  • Lower-Price without heater/bluetooth: 24 Volt 100Ah & 48 Volt 100Ah
  • Notice: Can only be used on 12v systems, cannot be connected for 24/36/48 volt configurations without an external balance management system.

*10 year warranty only applies to batteries purchased through Currentconnected.com

In stock, ready to ship!

172 in stock

$1,200.00

Description

Footprint Dimensions (LxW) 11.9 x 7.9 Inches
Overall Dimensions Including Handles & Terminals (LxWxH) 12.9 x 7.9 x 12.3
Weight 47.6 lbs

Additional information

Weight 55 lbs
Dimensions 14 × 11 × 11 in

Charger & Inverter Settings

General settings that apply to most equipment.  For Victron BlueSmart Chargers, please refer to the BlueSmart product listing page for exact parameters.

Multiply voltages by 2 for 24v systems and by 4 for 48v systems.

Charge Current (Per battery): 40a Preferred (50a Maximum)
Absorption Voltage: 14.6v preferred (14.4 Minimum)
Float Voltage: 13.8v preferred (13.6 Minimum)
Equalization: DISABLED
Low Voltage Disconnect (LVD): 11v

Equalization:
MUST BE DISABLED.  SET DURATION TO 0 MINUTES.
If you can, we recommend setting the equalization voltage to 14.6v.  With this set at 14.6, if an equalization is somehow triggered, you will not damage your battery.

Victron Settings For SmartShunt & BMV-712 / SOK Battery

Battery Capacity: Varies depending on system.
Charged Voltage: 13.8 (*2 for 24v & *4 for 48v Systems)
Discharge Floor: 10%
Tail Current: 2.00%
Charged Detection Time: 3m
Peukert Exponent: 1.05
Charge Efficiency Factor: 98%
Current Threshold: 0.10a
Time-to-go averaging Period: 3m
Battery Starts Synchronized: Disabled (NOTE: you will need to fully charge your battery to sync up SOC%)
State of Charge: 30% (NOTE: Set this to 30% with brand new, untouched batteries.  They ship at 30% SOC%.)

Comment on Discharge floor:
Let’s say you setting this at 10%; when you get to 10%, the Smartshunt will indicate 10% remaining and 0 minutes until empty.  If you choose to fully discharge your battery (not recommended) then set this to 0%.  If you want to be more conservative on your time remaining, then set this to 20%

Settings for Victron MPPT Charge Controllers:

Battery Voltage: Set depending on system, normally 12v.
Max Charge Current: OK to set as high as desired, but no more than 50a per battery
Charger: Enabled
Battery Preset: User Defined
Expert Mode: ON
Absorption Voltage: 14.6v
Float Voltage: 13.8v
Equalization Voltage: 14.6v
Rebulk Voltage Offset: 0.40v
Absorption Duration: Fixed
Absorption Time: 15 Minutes (This allows for proper cell balancing)
Tail Current: Disabled
Equalize Current: 0% (For safety we don’t want equalization at all.)
Automatic Equalization: Disabled
Equalize Stop Mode: Automatic (On voltage)
Maximum Equalize duration: 0 Minutes
Manual equalization: DO NOT CLICK START
Temperature Compensation: Disabled
Low Temperature Cutoff: Disabled (unless you add a temp sensor, the BMS has this protection built in)

Settings for Renogy Charge Controller (Wanderer, etc.)

IMPORTANT: For battery type, select “USER”

High Voltage Disconnect: 15.0
Charge Limit Voltage: 14.6v
Equalize Charge Voltage: 14.4
Boost Charge Voltage: 14.6v
Float Charge Voltage: 13.8v
Boost Charge Return Voltage: 13.4
Over Discharge Return Voltage: 12.0v
Low voltage Alarm:11.8v
Over Discharge Voltage: 11.0v
Discharge Limit Voltage: 10.5
Over Discharge Delay Time: 5 Seconds
Equalize Charge Time: 0
Boost Charge Time: 15 Minutes
Equalize Charge Interval: 0
Temperature Compensation: 0

Reviews

There are no reviews yet.

Be the first to review “SOK Battery | 206Ah “H” 12v | Heated & Bluetooth | LiFePO4 Battery”

Your email address will not be published.